Is there a tilt circuit switch in that hold path? I think I've had that problem before. Power to the hold relay must be checked at each switch on its path.
You're currently viewing posts by Pinsider stashyboy.
Click here to go back to viewing the entire thread.
Is there a tilt circuit switch in that hold path? I think I've had that problem before. Power to the hold relay must be checked at each switch on its path.
I think I meant those two tilt switches labeled bounce switch and anti-cheat. (aren't those part of the tilt circuit?)
Quoted from Gov:I hope you get it working. I am ready to kill some monkeys!
You must have watched Bowen doing that here!
I used to own a JPrincess, lot more fun than I had imagined. You'll get it running correctly, you've got Dirtflipper in your corner!
Quoted from jdoz2:I checked all the switches on the s relay and everything checks out with a meter. I dd notice that three of the switche had continuity even though they were open. Not sure if that's because one of the latch relays were opened/closed? All the anti cheat swotches check Out with a meter too.
Here are those switches just incase that does matter. On the first image the bottom switch has continuity even though it's open.image.jpg 476 KB
DF can explain this better than I, but you have circuits that have both open and closed switches, so it's likely that's the case here. The meter reads thru the back loop. During operation, the score motor and other relays may isolate that switch so it can do its job.
You're currently viewing posts by Pinsider stashyboy.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/jungle-queen-reset-issue?tu=stashyboy and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.