Any mods connected to J116-J118? I know lighted flipper buttons are too much for the driver board. Pretty much same with LED strips that run off these connectors.
You're currently viewing posts by Pinsider PinballManiac40.
Click here to go back to viewing the entire thread.
Any mods connected to J116-J118? I know lighted flipper buttons are too much for the driver board. Pretty much same with LED strips that run off these connectors.
Quoted from The_Pump_House:Assuming I need to change BR5 out I should do the corresponding cap as well right? I imagine that it's already been changed as there was a tag on the F116 fuse from Chris Hibler
These are suitable replacements?
15000 UF 35V (https://www.marcospecialties.com/pinball-parts/C15KM35VR)
BR 35A 400V (https://www.marcospecialties.com/pinball-parts/KBPC3504-W)
Those are suitable, but I do not expect the capacitor to be a failure. They do not normally short out, especially these. Plus, they are very hard to remove from the board, so I would not even advise to try to remove it.
You're currently viewing posts by Pinsider PinballManiac40.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/judge-dredd-f116-low-voltage?tu=PinballManiac40 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.