Judge Dredd
Bally, 1993You're currently viewing posts by Pinsider Bakerman.
Click here to go back to viewing the entire thread.
The wire is meant to rotate, no bend. The "hump" should raise up and push the target back. My JD is not availbale at the moment but I think that the end of the wire at the solenoid is not supposed to go through the split pin. Maybe, if the end of the wire was inserted in the slot in the solenoid plunger, below the split pin and above the spring then the wire would rotate rather than bend.
Hope that helps a little.
You're currently viewing posts by Pinsider Bakerman.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/judge-dredd-drop-target-mech?tu=Bakerman and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Minneapolis, MN