I'm having the same issue. T-rex begins to raise, then chomps. He has raised about 1/8" to 1/4" when the chomp happens so he just knocks the ball out of the hole.
You're currently viewing posts by Pinsider lotr_breath.
Click here to go back to viewing the entire thread.
I'm having the same issue. T-rex begins to raise, then chomps. He has raised about 1/8" to 1/4" when the chomp happens so he just knocks the ball out of the hole.
Quoted from Jimmyapple:So I think I figured out why it’s not working. The tRex up and down motor will sometimes go all the way around and then sometimes it goes backwards. When it goes backwards it gets caught behind the down switch and then kicks back over. If I bend the switch so it triggers both ways it doesn’t work properly. Is the motor supposed to go both ways? Or is it just supposed to go clockwise? I watched the times it ate the ball and it only ate the ball when it went clockwise.
[quoted image]
Found this in the manual, so it looks like it does turn in both directions.
trex motor (resized).JPGFound the problem on ours. It was the classic broken wire in the harness. I figured it out by using the t-rex test mode. The jaw would snap perfectly in every position except all the way down. As soon as t-rex moved up just a fraction of an inch the jaw would start working again. I just spliced in a 1 inch piece of stranded wire, soldered it and wrapped it up in electrical tape. Works perfect now!
Quoted from winteriscoming:That's a diagram of the left/right motor and bi-directional relay for it.
The only motor that is bi-directional is the left/right motor. The up/down motor should only be turning one direction. The movement in that one direction makes the t-rex go down and up.
Oh, good catch. That does make more sense!
You're currently viewing posts by Pinsider lotr_breath.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/jp-trex-issues?tu=lotr_breath and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.