New to the club! Did you ever figure this issue out? When I go to the wheel adjustment and try to match my wheel up with what the display says as soon as the wheel spins again it doesnt match up anymore.

Suggestions?

Having a bit of difficulty finding the wiring for the GI relay on the backbox. Could someone snap a quick pic of the wires for the 7 pinn connector?

Mine was burned up and I'm going to redo the connector that was long ago hacked by some operator.

20240105_223636 (resized).jpg

That's perfect. I was able to find the other end on the Interconnect in the schematics, but the relay was eluding me.

Thanks!

Thanks for the assistance, I was able to get this one fully playing again. Rubber, LEDs, and a fresh new upper playfield are on the way! The before and after on Jokers is always great.

20240106_215705_resized (resized).jpg

Just a couple of pics as I get the new Jokerz upper playfield installed. Money well spent. The difference is astonishing!

20240117_171234 (resized).jpg

received_369987158973679 (resized).jpeg

I just like them because of the ease of use. They take 2 seconds and snap right in. Here's a link if anyone needs some. Push in Rivet, Keyhole, 1/8 in, PK25 https://a.co/d/cevmi1w

I think the whole swap took me 2 hours start to finish including the time it took to clean the adhesive off of the decal underneath. In my experience, the hardest part of the whole deal is getting the playfield up off the support hangers to access the back. Jokerz is just a bit more tricky than most because theres a mech in the way.

Just about finished with this one. Mylar was still in nice shape so I decided not to pull it off. Full rubber and comet sunlight LEDs. Just a few more LEDs under the inserts and it will be finished.