You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
If x- and y-axis don't move, check for 20Volts on motor controller board under playfield.
Black and Red-White wire are supply to that board at J1 pin 10+11
Quoted from benman:Should i reflow
That won't hurt but mostly it is visible when solder is cracked.
Check the wires in connector J1, J2, J3 on the motordriver board and J126 pin 5,6,7,8 on Powerdriverboard
Check wires on Y-motor (Red-Vio + Blu-Vio).
Manually rotate Y-axis to halfway rod.
Activate coindoor interlock switch (20V present)
Briefly (1sec.) 'Ground' J126-8 (Blu-Gry) and/or metal tab Q32 on PDB. !! Careful here because the motor won't stop when outer limit has been reached.
Does that make the Y-axis move ?
You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/johnny-mnemonic-glove-wire?tu=zaza and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.