Question. Anyone else’s game have a block of styrofoam taped behind the play field backboard. Mine fell off but it was attached with double sided tape. I assume it stays on for dampening effect.

Thanks to all for answers. Yelo, can’t wait for your toys to arrive on Monday. Buying some White Lithium Grease to quite that spinner today.

Just ran a test on mine. Only issue is switch 63 is open. Looks like right left rubber switch in the top of the play field inside the magnet area.

Anyone else have a switch 63 issue they resolved.

Checked and wires soldered on and no breaks

Thanks.

Looks like I solved my own problem. Just had to bend metal connector a bit as they were touching. Of course that’s the one switch I can see the won’t unscrew from bottom w\o removing another big piece.

Bye Bye Tom

D83ED4AE-A177-4509-93F5-CCAB87A6A655 (resized).jpeg

I got mine from Walmart online. It was the last one. I’m sure there are more somewhere. SDTM mentions the exact type. Mine broke clean at the moveable waist and is almost the exact same size. Mine also came with a sword or gun to put in his hand.

NECA Pirates of the Caribbean Series 3 Captain Jack Sparrow Action Figure
$39.99

This is the one you guys want. Breaks clean at the waist. You have to snip the sword case and his fabric belt that hangs down. Dam near the same size as Tom.

Now someone tell me how to silence that spinning disk. I am about to put the Dri Lube on. I used the Lithium grease and that didn't help. Sad thing on mine is its off center almost rubbing on one side. I know once it is installed all you can do is move it up or down. JJP Tech said to try and bend the gears closer together. I said I'll probably break it. He said when you buy a Ferrari you shouldn't have to mess with much and if you do and break it we'll replace it.

IMG_0070 (resized).jpg

There are two screws holding Tom on top of barrel. Thats it.

All hail Yelobird. Just got all your other toys. Always love your mods. I'll be ordering that the minute it comes up.

Hello,

Having a problem with the Auto Launcher. I know both pieces of metal are supposed to be touching the Ball. So I bend the metal on each side to make that happen. After about two successful launches it goes back to a launch where ball hits side and never makes it over launch ramp. Only thing I can think is there is too much play on the launch mech from side to side.

I see its held on by a coder pin. Makes muli-ball tough because you have to hand launch each ball.

Anyone else have this issue. Thanks.

IMG_0086 (resized).jpg

LTG. I was hoping you would answer. Don’t think mine has any washers. Gonna tackle that in the morning. Thanks so much.

I am the lucky Pirate that got to beta test this for Rob (Lermods) you won’t be disappointed. Many selections on the lighting ie Brightness, Strobing speed. Everything hidden. Does not interfere with chest shot in any way. Great looking mod.

I can’t speak for Rob but ask him if he can do Red.

Hello,

I know its been discussed many times but I just go my Cliffy set and heard Black Pearl is recommended to be removed to get to map area.

Which post # talks about removing ship. Thanks in advance.

Writing it down. Thanks LTG