So this is the second time I have had a Judge Dredd - and had the exact same problem. When its the only game on the left flipper is snappy and does what it should. Power on just a few things and the left goes limp. I tired everything before with regards to rebuilding, but in the end the only solution was a dedicated outlet. However, I don't have this option anymore. Anybody have any ideas on what to do?

Thanks - would that cause problems if power was slightly drained from the outlet… the problem existed even if just one game was on.

Just the lower and just when other stuff is on. I'll check voltages clean and report back. Also the others might be less but not as bad as the left one - like I said same exact issue on q different dredd

Ok I think your on to something thanks for the help - it just did not follow my logic tree if you will. Nothing better then asking for help and then going are you sure!

I'll try all what was the solution on ij?

So this seems to have been the solution small eos adjustment.

Game plays fine by itself other games on = limp flipper.

Not many balls played so the coil was not overheated yet but it was on the way so it would have gone limp by itself.

Not sure I understand the logic in it but noticed when I went to clean the optics that the coil was warm so I adjusted eos and problem went away before the coil could cool.

Also thank you all for the help. One idea leads to another and with a pin today's fix is tomorrow's hey I thought this was fixed