As visible in the attached image, the crane is not passing above the ring at the right time to pick up the ball.
How do i calibrate this?
As visible in the image, the slotted holes only give room to adjust the ring goint the other direction.
You're currently viewing posts by Pinsider m111111.
Click here to go back to viewing the entire thread.
As visible in the attached image, the crane is not passing above the ring at the right time to pick up the ball.
How do i calibrate this?
As visible in the image, the slotted holes only give room to adjust the ring goint the other direction.
Hey, thanks
But, the crane arm-screws only adjust the cam that animates the height of the crane right?
so by opto-interruptor i guess you mean, adjusting the set screw / shaft position on the big wheel under the deadworld ring?
Just to make sure we are talking about the same adjustments:
Attached images:
In "Lifter Assembly" image, do you mean nr5 or nr17 ?
And
In "Planet assembly" image i guess it would be nr 8 ?
To me it seems as if the crane position ends up perfectly above where the ball should be, the problem is that the ball is not there, its 2cm further down the rotation of the ring.
Screenshot 2018-10-09 at 21.38.18 (resized).pngScreenshot 2018-10-09 at 21.38.51 (resized).pngYes, i think i might need to adjust nr8 on the planet.
I tried with a tiny hex key, however it seems to be really stuck, i am worried i might break something there.
Any idea about what hex key / tool / size needed for this?
You're currently viewing posts by Pinsider m111111.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/jd-deadworld-ring-amp-crane-not-in-sync?tu=m111111 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.