Hi everyone, I'm looking for plastic 02. Mine is broken. If you have a spare, used or NOS, let me know.
Nate, I cannot take new pictures as my playfield is currently stripped but here is one that might be helpful:
Hi, I am putting back together my GE and I am missing a picture of the slingshot assemblies with their wiring. Anyone here has a pic of the assemblies or just a hi-res of the back of the playfield. Thanks for your help!
Quoted from robm:
Am repairing a Goldeneye for a mate and the rod that pulls the tank trapdoor keeps falling off at the underside of the ramp (ie: above the playfield). There is a tiny groove cut into the shaft, so it looks like an e clip or something could go there to secure it, however not sure that e clips are made that small? Does anyone have any details on how this is secured. The manual i have is a prototype manual and doesn't have a part listing for that or a drawing.
Or any ideas on how i could secure it so the wire rod doesn't keep falling out
The rod is secured by an E clip 1/4 inch diameter, part number 270-5002-00. See #16 in manual images below.
Quoted from robm:
OK, so i ordered that part number (which has been replaced by part 20-8712-25), however its a relatively large e-clip - i think it describes a 1/4" opening.
So in relation to the really small e clips on the tank shaft, does anyone have a part number or size please?
Sorry the manual had the wrong part number. What's the size of the shaft ? Part number for smaller E-clips are 270-5000-00 / 270-8712-12 (1/8" shaft) , 270-8712-14 (9/4 " shaft) and 270-8712-15 (5/32" shaft). I can't remember which one I used but I bought a lot of various E-clips at a standard auto store. The size needed is not specific to pinballs.
Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside