Okay, I have the parts all worked out. The Anubis works on the static Pro using supplied hex standoffs or the moving Prem/LE. Both mount using a hidden mount that slides over the supplied button top screws and tightens from the front using a supplied min-hex wrench. Total installation (removing existing plastic and installing 3D Anubis) is about 10 minutes on either the Pro or Prem/LE. Here are some pics of the installation on a Pro:
Hex standoffs installed with the button top screws about 1/2 way in to leave room to slide the mount over them:
Example of the bottom of the Anubis showing the receptacles where the screws slide in on the back:
Using the hex wrench to tighten the Anubis on the mount through the small access holes in the front:
I still think uplighting is the best way to show it off, but it was taking too much time to source the parts at a reasonable rate and put together the kit in the best way, so I'm not doing a kit with the external lighting included.
Anubis kit will come in a box with the following:
1 x Anubis figure
2 x Hex standoffs
2 x Button Top screws
1 x hex wrench
Price is $69, shipped in the US. I have the interest list started with anyone that already posted that they wanted one. Anyone that wants one that HASN'T posted that in this thread, PM me and I'll add you to the list. These take a LONG time to print and they'll go out first come, first served. I expect to start shipping them in the next 10 days or so one. Once the initial orders are done, these will go in the Pinmonk store and it will be $69 + shipping.