I installed Radcals on my JJPOTC - very happy with them!

I do have a question about polishing them. The front piece required dremeling out some odd-shaped holes, and unfortunately the Dremel skipped and left a scratch across Barbossa's belly. It's pretty hard to see, but if I wanted to polish that down to smooth what is the recommended approach/tool?

I tried Novus 3/2 without much improvement.

IMG_0011 (resized).jpeg

IMG_0017 (resized).jpeg

IMG_0018 (resized).jpeg

IMG_0019 (resized).jpeg

IMG_0028 (resized).jpeg

Thanks for the reply, I'm not too worried about it since it is so hard to see. Very very pleased with Radcals overall and will get them on all my JJPs going forward, either through buying CE or addon to LE.

Yes, $400 for the set.

I had art damage and CE envy. Radcalling solved both issues.

I did them on my JJPOTC on top of original art. The flipper holes did not line up, and there were two holes on the front piece that needed customization.

I used a Dremel with the cylinder that looks like sandpaper and it worked easily.

The only caveat is be very careful, as the Dremel can get away from you and skip across your expensive new Radcals.

They were, but I had to extend them to make them line up where I wanted. This was on JJP Radcals for POTC, I cannot confirm what is done for other games.

JJP. I ordered them direct and installed them myself.

If the flipper holes need to be cut out manually now that is probably a good thing as you won't have the alignment problem I did.