When will we be able to see the full list of available Rad-Cals? My IJ is screaming for these!
You're currently viewing posts by Pinsider underlord.
Click here to go back to viewing the entire thread.
Quoted from Highclasspinball:If I would not cut the holes for flipper buttons everybody could put the decal right to the front... but the button hole would need to be cutted in with a dremel or any other hand milling tool.
Do you think that would be an option?
Regards,
Mirco
Yes. Options are great!
C'mon Pinside! These Rad-Cals are, well, Rad.
New tech good enough for JJP, good enough for Bally/Williams!
Quoted from bigd1979:These are much better than decals imo and a lot less prep is required which is huge.
This, and being scratch resistant to the extreme and will he shiny... forever. Aww hell yeah.
Quoted from hoby1:Nice job making these and probably tough as nails.......... but I prefer a nice clean stock look with crisp edges and a non reflective finish. Too much color disparity between the cabinet and the decal.
Just not my cup of tea.
I dunno man. The JJP Rad-Cals look phenomenal.
Quoted from harryhoudini:highclasspinball do you have a recommendation for re-adhering a small section of rad cal that is pulling away from the cabinet? It's buckling a little bit because it is hitting the side rail. I think once it is readhered it should be ok. Someone suggested Rapidtac application fluid to reactivate the adhesive, but I don't know the stuff at all. Any suggestions?
Rapidtac is only to help new adhesion, not actually a glue itself. I use it for all my decal installs.
You're currently viewing posts by Pinsider underlord.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/installation-of-rad-cals-and-pics-of-medieval-rad-cals-installed?tu=underlord and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.