my poa isnt working, it doesnt work in test mode and optos dont trigger. I removed motor and hooked power to it and it spins and gear looks nice, so i assume motor is good, i ordered the great lakes opto board. Theres another board (see pic)under pf that motor hooks directly to, i think its called brige driver board in manual, a-15946. I dont see the red light on, should it be? where to order that board if its bad? how do i test it? thanks, bear with me im new to fixing pins.

DSCF2804.JPG

my indy doesnt have the stock opto flipper buttons, this is how i bought it. It has some leaf switch set up, is this bad? feel like doing a repair on kauai? its 85degrees now

DSCF2805.JPG

man i didnt even think about that, without the original opto flipper board theres no way for it to work? the guy i bought it from says the poa was working a few months ago and stopped, is this possible with these leaf switches for flipper switches?

can i just leave it as is?

ok i finally found and ordered the motor board to poa, thanks to you guys. The next board i would like to replace is this.....
my Indy calls for a A-13901-2 opto ramp switch board, it doesnt seem to be sold anywhere. I see the A-13901, it looks the same except it has 7 idc plugs instead of my 4 in the same configuration. Does anyone know if I can buy that one and just not use the 3 plus on the left? Heres a pic of mine, no comment on those idc's, im going to replace all those when I get a new board.

P.s. remember if anyone is coming to Kauai, look me up, pins to play and I can show you around.

DSCF2818.JPG

thanks Chris, im ordering a new ramp opto board. Its $35, start new, replace the idc's, go from there. I have no idea how to fix or check boards. Metal and Hawaii dont mix.

guys, the wires on the idc ramp opto board in pic, does that look like a 18/156 or 22/156?