Hi,
I changed bridge rectifiers (BR1 and BR2), and since then the motor (idol) rotates very slowly and still throws bullets from the magazine.
As disconnecting the J118 engine revolves normally.
:/
(Topic ID: 173890)
You're currently viewing posts by Pinsider fly.
Click here to go back to viewing the entire thread.
bridges change, continuity tested are ok,
I turn on the machine, tapping still one coil, after a while, throws all the balls from the magazine, then stops.
When I run the game again throws all the balls, and is so still.
I put on a plate with Dr. who (CPU and POWER), and still the same,
I disconnected Fliptronic, and still the same
Yes, I tested as the bridges were not installed.
installed a Power Board with Dr. who, and still the same
1 week later
Promoted items from Pinside Marketplace and Pinside Shops!
Folsom, CA
You're currently viewing posts by Pinsider fly.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
