Yet another documented playfield swap for IJPA.
For the past 3 years, I've been looking for an IJPA. Finally pulled the trigger on a partially restored one. The one I got had a sold cabinet with new decals installed. Boards in decent shape. Currently has Rottendog driver board, but I have Coin-op fixing the original board.
I purchased new reproduction playfield from Mirco. Looks to be in great shape.
I've done a few swaps on older pins (Bally ST, High Speed, and Space Shuttle), but never a more modern pin. In many respects, I think it will be easier since there are not extensive ground braids.
My strategy is to do individual sections one at a time and add molex connectors for key mechs like slingshots and pop bumpers. I may even do more, but at least those key ones. A little more up front work, but in the end will make cleaning and moving much easier. Also, I much prefer any soldering work off the playfield, not while things are attached.
As I go, I will sonic clean all parts and polish where warranted. Anything seen or involved in mechanics will get plenty of TLC.
Will capture lessons learned and parts I used and added and where I purchased to help the next guys.
Feedback and recommendations are welcome.
I will post iCloud links to all my pictures to document work.
4DC7CA78-5447-4330-A607-5D143BA8B6C1 (resized).jpegIMG_0386 (resized).jpegIMG_0475 (resized).jpegIMG_0477 (resized).jpegIMG_0489 (resized).jpeg