Quoted from dmacy:It’s a Mirco TZ using the 3rd magnet version.
That's an early run original playfield. The lock insert is green! I have a TZ "in a tote" that is waiting for a restoration with a Mirco 3rd magnet version. If only I can find the time.
Quoted from dmacy:Originally he was going to populate the magnet hole and work out getting the wiring done later. We may have a plug and play solution in the near future and hoping that if it comes to fruition, this will be the one that gets tested.
If your solution doesn't work out then I have a pass-through board that supports the use of a standard opto pair. The board provides the transmitter drive and switch matrix interface. I believe the hardware can be acquired from various merchants. I also have the 8 high power driver board but I am sure you have the experience to be able to install the TIP36C and heat sink on that board.
If you want to add support for the prototype/sample flasher board in the door panel I have the boards that support that. You will need to add the wiring to the harness.