Hello everyone!
I am so close to replacing my GI connectors for the PPB on my tmnt data east pin and am having difficulty getting the wires fully inserted into the plastic housing.
I have put soooo much pressure on the tool and I can't seem to get these wires to budge past a certain point. Per insertion tool instructions, the tool needs to be pushed flush down with the plastic housing, and done on a flat surface. I've had to push on an elevated flat surface since the wire length limits me from pulling out of backbox and pushing down with full weight. I'm hopeful someone can give me tips. So close to finishing!!!
Thanks!
20181228_174922 (resized).jpg20181228_174935 (resized).jpg20181228_174949 (resized).jpg