I know this isn't exactly pinball, but wondered if someone might be able to help. We need the solenoid plunger for our ICB and I can't seem to locate it anywhere. It's part # 61-00317-001 in the manual. I've attached a photo from the assembly drawing as well (it's marked as item #2). It looks different than a lot of pinball plungers, smaller E-clip base. If you guys know where I could find one, or an equivalent that would work, I'd be very appreciative. Thanks!
Unobtanium. You can use this one and cut it down to between 2-1/2" and 3-1/8" with a metal saw blade and a bit of diligence. The original plunger is 2-1/2." Also be sure to use a wave spring washer in lieu of the original e-clip and rubber ring. There may be an even better suited plunger out there as well, but this one will work.
https://www.marcospecialties.com/pinball-parts/A-17767
detail (resized).jpg
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/ice-cold-beer-part-needed and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
The Woodlands, TX