I picked up a ICB last night. It had been sitting in a warehouse for years.
The first time I plugged it in it fired right up but the right side of the rod didn’t move so I turned it off and found the belt had dry rotted and broke. I ordered a new set of belts last night so no biggie.
However, after I turned it back on I’m no longer getting any displays and even though it will coin up it won’t start a game. Anyone have any ideas where to look first?

7F564F3A-2483-433F-B5D0-572CC8EDBF03 (resized).jpeg

I purchased the power supply and installed it as it says to in the manual for the new power supply. However, I don't seem to be getting any power at the new power supply.
In the manual it says to use the clips that are provided and to attach them to the AC wires going to the light fixture. What am I missing here?

87035412_10219138125377762_5033559808142213120_n (resized).jpg

Capturedsf (resized).JPG

Got cha. Nope, I’m not getting power to the new supply. There’s no light.
However, the light in the top comes on. Where are you getting your power from on your supply?

I tested all the fuses on the old power supply and the one in the black screw, they’re all good. When you say “power brick/light pins” are you referring to the new supply?
Sorry if that’s a stupid question.

That’s perfect! I checked and I’m getting continuity from the plug to the power supply.

Yep, marquee light works. That’s all I’m getting is the marquee light.

Whoops! Sorry about that. Yep I’m getting 120v at the 2 and 3 in the connector on the board.

And I’m getting 118v at the power supply now. But I’m still not getting the game to start. No coin up no display no sounds.

That’s the first time I’ve used them. They came with the kit for the power supply. Should I remove some cover and solder it in place instead?