You're currently viewing posts by Pinsider heme.
Click here to go back to viewing the entire thread.
so the two limit switches for the cannon are ok? like Lermods suggested
I know it's the same setup for the xmen iceman ramp and the crossbow on TWD.
the disk moves till it hits the cherry switch then it moves back till it hits the other cherry switch. Guess that's what's happening, but the other switch isn't closing.
Quoted from Strummy:No. The cannon doesn't know where it is. Everything is out as depicted in post 14
did you do a continuity check btwn the backbox on the J1 green/ yellow wire and the various switches they are connected to?
Just looking over the basics again.
if it's not Q4 then eshhhh. that probably means surface mounting repairs or a new board.
You're currently viewing posts by Pinsider heme.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/i-screwed-up-my-ac-dc-premium?tu=heme and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
