Yes.

Also, you could make one:

Great Plains Electronics

https://www.greatplainselectronics.com/products.asp?cat=77

Connector:

Part Number 09-01-6191

Pins:

Part Number 08-52-0072

If you can't get one made, I'm sure I could make one - just need pinouts.

If it's the same as used in Genesis or Raven, I've done those myself successfully. One side goes to board, second side splits and goes to display panel and power.

Tool for extracting those pins - get a set of jewler's flathead screwdrivers, find one that almost fits, and grind down the edges (or file them down) until they fit. You'll want to push in from the card edge (where it plugs into the board) side with the screwdriver.

This will take some time, don't pull hard, you'll be cursing your luck until you get it down.

But yes, there is a tool, and chances are if you order it, it will break after about a dozen extractions.