Huntington, IN
I just read though the tips , thanks all. I'm not a huge fan of Soldering either. I guess I should buy a little flux, I always thought that since I was using Rosin Core solder that I didn't need it?
(Topic ID: 17037)
You're currently viewing posts by Pinsider billinindiana.
Click here to go back to viewing the entire thread.
Quoted from Dawson:Flux seem to transfer heat , I love flux , then I use a tooth brush and alcohol to clean that flux off after soldering ..
Do you clean everything you solder or just PCB's? e.g. Wires to Coil lugs ?
Quoted from Frax:My complaint with alligator clips and "helping hands" that have them is that a lot of times they maul the wire insulation. I'm being nitpicky probably, but it still bugs me.
Could always wrap the alligator clips teeth with a little duct tape or electrical tape? Just something to keep the points from indenting the insulation, but still do the job.
Just a thought, I have never done it..
You're currently viewing posts by Pinsider billinindiana.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
