I am struggling with the supercharger on my getaway. The machine works but a hot up the ramp will not initiate te supercharger. It makes one revolution and the rolls back down the ramp. I have put the driver board out of my T2 in it and the supercharger works flawlessly. I am going blind looking at this manual on IPDB. Anyone care to point me in the right direction on solving this. I’d greatly appreciate it.

You’re joking. Is there one fuse specifically on the driver for the supercharger? I’m going to just check them all real quick and see

Sure enough. Problem solved. Fuse looked good but wasn’t. Thanks

Thanks so much. I will keep that in mind moving forward with it. Hopefully there are no other issues. The original mpu had some major acid damage and was not registering the correct switches. Tons of coils were locked on so the driver had some blown fuses. I replaced them all and just missed f106. It appeared ok visually but sure enough when I check continuity with me dmm there is none.