This is the latest version of the AFM kit. I haven't hooked it up yet. There were a few different versions of the PCB. From what I get out of it, The red is +20V which can be gotten from the flasher + side. The trigger wire appears that some kits used blue and some used purple. Then there's the orange and purple wires in the STTNG kits. If you have the STTNG kit, I would go with the colors in the initial post in this thread. I'm relatively certain that the trigger wire goes to the drive side of the flasher. Interestingly enough, on this PCB, the blue wire is connected to the pin labeled "key". However, when you look at the bottom of the PCB, that terminal is connected to something. Black is ground and green and white aren't used for POTC. On the motor side, red is connected to the pin labeled 20V and black is connected to DRV. In the 3rd pic, you can see where the jumper is. I have no idea what the jumper does or if it will fry something if it's wrong.
IMG_0818_(resized).jpg
IMG_0821_(resized).jpg
IMG_0819_(resized).jpg
IMG_0822_(resized).jpg