Please check my work here. I have the Cointaker Red Tremor Shaker. I installed the shaker in the bottom left corner and mounted the control board above it. I tapped into the top post wire of the coin door with the red wire coming from the control board. I ran the signal wire from the control board to the fifth position in the backbox connector using 22 gauge wire and Pinball life connection tool.
From what I understand the signal wire is also the ground that runs the motor? In the standard configuration there is no dedicated ground for the Cointaker setup - only signal and power on the control board on one end and the other end of the board has a ground and power wire going to the motor, so the signal wire must complete the ground, correct?