You're currently viewing posts by Pinsider thepita007.
Click here to go back to viewing the entire thread.
Quoted from toyotaboy:I don't see replacements anywhere.. not even ministry of pinball. This blog talks about testing the moon:
http://pinballnovice.blogspot.com/2015/12/apollo-13-my-moon-my-magnet.html
I'd say I'd pop mine open, measure, 3d model and 3d print a replacement, but the crater texture on the outside is going to be a pain to recreate.
I just purchased the game the other day
Should have gone thru it more before playing it for a awhile. Seller stated moon was melted but I didn't realize coil was locked on still should have checked.... Lesson Learned!
Since then, I have repaired the circuit for the moon and ordered new mag coil. The circuit is a very poor design, it goes thru the segment display board than to the aux driver than to the coil.
A VERY IMPORTANT THING TO NOTE IS THAT IF THE BLUE/WHITE WIRE ON J2 DOES NOT MAKE CONTACT THE MOON WILL LOCK ON. J2 USES A IDC CONNECTOR AND VIBRATIONS CAN AND WILL LOOSEN THIS WIRE OVER TIME!!!!!!!
To repair the circuit I had to fix the following (note this also repaired the 7 segment countdown display):
Bad components on 7 Segment Display Board:
------------------------------------------------------------
U2 - 74LS273 (if your moon works fine but countdown LED display does not replace this chip)
Q4 - 2n3906
Q5 - 2n3904
Q6 - 2n3904
Replace J2 IDC connector with molex connector.
Bad components on Moon Aux Board
-------------------------------------------------------------
Q3 - 20n10L replaced with IRL540 (NOT IRF540!!!!)
D10 - 1n4004
Quoted from toyotaboy:I forget Lloyd sells stuff, nice find.. I'd JUMP on that
i messaged them last week no reply are they open?
You're currently viewing posts by Pinsider thepita007.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/houston-weve-had-a-problem-here-%e2%80%93%e2%80%93%e2%80%93-apollo-13-club-%e2%80%93%e2%80%93%e2%80%93-everyone-welcome?tu=thepita007 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.