Running the beta code. Upon boot up, about 10 seconds in all the coils start firing. If I open the coin door the firing stops and boot up completes but Game won’t start. No ball ejects even though graphics are working and audio is talking through instructions. Some switches work If I touch with my finger but no flippers no ball eject. Basically no game play.

Thanks for the post but no, all 6 balls are accounted for and the coils firing start way before full boot up. And once it boots (I open the coin door to stop the coils from firing to let it finish the boot) some switches register but the flippers don’t work, ball won’t eject, pretty much dead.

Grey, purple, blue twisted wire is disconnected from under the Houdini’s just above the flippers. Assuming that is where the wire needs to be plugged in, I have a problem. There are two male possibilities next to each other on the board right below the ribbon cable.

To which male plug do they attach. The two look to be keyed identically (all 3 male pins to femail plug).

4F861A2A-2733-4E76-8A6F-540E9EAE2FBF (resized).jpeg

Got it reconnected and playing to perfection. American Pinball service is amazing.