Quoted from Jeffswack:My goblin target head broke off. I ordered a new one but need to install it. I can't find any info on how to replace it. How do I go about this
You are going to love this one. This is how I do it.
Turn the game off. Above the playfield. Lift the character up and secure it so it doesn't drop back down. I use a vice grips on the side of the carriage.
You have to remove the trap door. It has two posts going into the carriage. Each post has a small clip and a spring. I put a magnet nearby for when things go flying so you don't lose the 2 clips or 2 springs. Remove the trap door flap. Let the carriage go back into the playfield.
Under the playfield disconnect the character connector, up/down switch connector, and coil connector. 5 screws hold the assembly to the underside of the playfield. Remove them and remove the whole assembly.
Take it to your table or work bench. Take the thing apart so you can get the carriage out of there. Then remove the two screws holding the character leaf blade to the carriage. Then you can get at the leaf blade switch to put on the new character face.
Then reassemble it.
Then be sure the character goes up and down smoothly. You may get lucky and it doesn't stick or bind. Or you have your work cut out for you. On one that is hard. I spent an hour loosening this, moving that tightening them. It's a barrel of fun to get it right.
Then stick that sucker back in the game.
LTG : )