The targets on my machine were really used, carved.
New targets switches are not cheap, High Speed has 15.
I figured it was worth buying the press and change only the plastic circles at $1.25.
The press pays for itself.

IMG_20130508_191934.jpg

Yes, that's before and after.

It's camera lens. It's exactly the same, but new

Make sure you get the long head die too. The 1" is not long enough to rivet ramps and some pieces.

Yes, this particular connector has two bunch of 4 wires connected together.

IDC connector: cables are punched in.

Molex 41695 Series connectors: each cable is crimped to a contact pin, which is then inserted in the housing. You can then remove the pin if you want, redo the crimp, etc...

Trifurcon pins can't go in an IDC connector.

This is what I hear. One small "beep".

Buy yourself 2 meters of 26-pin flat cable and some connectors.
I had display problems like you because of the cables.

I had displays problems and decided to order a XPin kit, 5 displays and a new display board.
The XPin kit came with 2 new cables. New displays connected with an old cable were behaving exactly like the old displays.

http://www.pbresource.com/pfswitch.htm
CTRL-F : A9374

Each face comes with a rivet but, in my case, it was 1/32" too long.
I don't remember which length I ended up using... something like 6/32" I think.