Hello everyone,

I got a High Speed last week!

I used to play this table as much as possible when it came out. I think I was about 13 years old.

My pin had a malfunctioning CPU board, some acid corrosion that got repaired, I'm about to go and pick up in a couple hours!

I went through the playfield and did all the rubber replacement, cleaned the playfield, put new balls in.

My question is I have two large rubber rings that go under the ramp, but the job looks awful to do. Any tips? I did find one thread, but It doesn't give me the good feelings...

I have very little to do, as the machine was missing the San Diego spinner (replaced with an old, heavier EM one for now) and a couple of plastics. Otherwise, pretty amazing condition, fairly clean, though a bubbling mylar to deal with some day

I'll post pictures soon!

Anyway, if you have any ramp removal advice, I would appreciate it.

Thanks,

Tim

OK, I have no issues with taking the playfield out. I'm going to enjoy my new game for a bit first!

Thanks,

Tim

20160930_124619 (resized).jpg

Hello,

New issue with machine. When I power on, everything OK in attract mode, however, flippers activate when you hit the respective flipper button. This happens before a credit is inserted or game is started...

If the issue is related to the CPU board, also let me know, as I just had most of the board repaired, and want to know where to look!

Thanks