OP

Quoted from Freeplay40:

Been a while since I posted in here. Usually I just reply back for those interested in these ramps via email and I've had a lot of requests for this ramp recently. Since there is a lot involved with this ramp I started copying and pasting the detail for this one in the emails. Thought I'd just post it here....
High Speed is one of the ramps that I offer assembly on as well as a couple other "options". There are three metal pieces on the original ramp that must be transferred to the new ramp...Specifically...the large bracket on the left side, the main plate under the center and the small bracket at the exit. These pieces need to be riveted to the new ramp. I offer to do this as well as polish all the metal for $20...it's a good deal if you are not set up to rivet....almost everyone has me do the assembly...I've assembled over 100 of them. Additionally, most have opted to relocate the stop light to the left rear corner. This requires an extension to the games wire harness and I offer a Molex extension to make this easier. Lastly, the ball guide on the uphill inside turn is usually pretty beat up...I can install your old one or I offer a new spring steel piece for that for $5.
The ramp itself is available in clear or transparent red.
So, in summary...
New clear ramp w/flap $90
Transparent red ramp w/flap $100
Shipping $16
Options:
Assembly with your parts $20
Molex Harness extension $8
New ball guide $5
Obviously for me to do the assembly, you would need to remove the parts and send them to me. As far as the stop light is concerned, I do not predrill for it to me mounted on the ramp.. You would need to do that and if you decide to do that, I will instruct you on how to do it.
If I do the assembly, I can turn them in just one day.