Question - the auto launcher works (set to a minimum of the 15 seconds ). And it gets the ball up the trough.

Trouble is on multi ball - it will kick a ball out but before the launcher fires another ball is kicked out and then the launcher can’t power two balls (let alone all 4)
Should there be an interlock so as soon it loads a ball it fires?

If I could lower the auto setting to 2-3 seconds I think it would be fine.

What’s the issue here ? Some adjustment in the settings or could an opto be out of adjustment ?

Well - thanks to "the wiz" - problem solved! It was the "shooter lane" switch - the entire wire form was missing off the switch. (Found it in the cabinet and get it working!) Ordered a new switch just in case, it didn't seem to have the same spring action. But at least that issue is solved!

Anyone else have issues where the ball doesn't always make it up the ramp during multi-ball? I've set the coil power to hard, and 90% it makes it, but thinking I need a more powerful coil (if one is available?)

Replaced the drop targets (these were worn so much they wouldn't stay up!)...added some missing light shields, replaced burnt bulbs and looking & playing well again. I did replace the Auto Launch coil with a slightly hotter coil (50 less wraps) but as "The Wiz" told me - it's probably an alignment issue, and the mechanism was a little loose, so I added a 2nd e-clip and that seemed to fix this issue. All balls launching like they're supposed to in MB! Yeah!

Just looking for the stickers to go on these drop targets if anyone knows where to get those? (Looks like originally they were just "Stern" stickers, but these had clubs/hearts/diamonds/spades.... anything to add to these white drops will be an improvement.

I put a slightly hotter coil but my friend thinks it’s the alignment The metal piece that rotates up and hits the ball. I placed an additional eclip to tighten that up and the coil mentioned and it seems to be working. Try the .25 eclip first. May do the trick on its own.

And you can set the coils to soft medium hard (12% up or down ). I think it’s adj 32?

Had one more call on this one, same issue. Looks like the two forks on the metal piece that hits the ball up the trough was very slightly kicking the ball into the left side of the rail - just a bit, but enough to slow the ball down. Bent the inside fork a small amount - kicks 100% now! Finally!

My friend/mentor always said it was an alignment issue, but couldn't see anything, until this.

Last note - I did have to make a final adjustment as it could then get in the way of the manual push rod, so keep that in mind as well.