Haunted House
Gottlieb, 1982That part will work, but the pinout is different. Therefore, legs would have to be re-routed.
It is closer to the MCP130-460HI/TO, but backwards. The "HI" indicates the pinout.
--
Chris Hibler - CARGPB #31
http://www.ChrisHiblerPinball.com/Contact
https://www.youtube.com/c/ChrisHiblerPinball
http://www.PinWiki.com - The Place to go for Pinball Repair Info
Got the pascal board installed and works great. Had to tweak a few settings to put it in HH "purist" mode.
Started the alkaline abatement process by removing all affected components and sanded. Also removed all the parts to perform the reset generator mod. Z2 and Z3 PCB holes and traces have some damage but I think a little solder flow and some new parts and it will all be fine.
Thanks
20220809_211531 (resized).jpgChrisHibler Solder alone is not able to bridge the gap in some of these traces. I bought some copper tape and planned on trimming and soldering this tape to fix these traces. Is this a good way to fix traces?
Thanks!
20220810_222112 (resized).jpg20220810_222101 (resized).jpgYour desoldering iron might be a tad too hot.
I use "trace wire" or clipped resistor leads to rebuild the traces.
Whatever gets it done...short of lamp cord.
--
Chris Hibler - CARGPB #31
http://www.ChrisHiblerPinball.com/Contact
https://www.youtube.com/c/ChrisHiblerPinball
http://www.PinWiki.com - The Place to go for Pinball Repair Info
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/hh-system-80-upgrades-and-modifications/page/2?hl=stvns78 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Chesterfield, MO