This is about as close as I get to my issue on my recently purchased SWEp1. My right spinner works fine, but the right drop target, never even noticed these things before I bought it, goes up fine, but only goes down if the target is struck. My daughter actually got a ball stuck behind the target as the target went up after the ball partially went up the right ramp and came back to get stuck behind the drop target. This got me doing some research, in which I discovered that both power connectors going to the drop targets drop coil were disconnected. I thought that very strange so I reconnected them and then found the reason. The drop coil continuously fires trying to retract the drop target. I can't figure out why it is getting a signal to try and activate the drop coil.
I see Lloyd has responded here before, so know there is probably a simple answer.

Thanks for the help.

Tim