You sent out the CPU board for repair, but in fact your problem is on the aux power supply. You will need to replace the coil diode and the driver transistor. Both of these parts are on the aux power supply.
You're currently viewing posts by Pinsider GRUMPY.
Click here to go back to viewing the entire thread.
You sent out the CPU board for repair, but in fact your problem is on the aux power supply. You will need to replace the coil diode and the driver transistor. Both of these parts are on the aux power supply.
Check to see if the jumpers are zero ohm resistors or not. If they are resistors then replace them with a paper clip. Reflow the AC relay joints.
This board had the pops and the shaker motor stop working, jumper W-4 zero ohm resistor went open only during a current draw. It would show voltage on both sides making it look like it was still good. So if you have the board out just change them.
3645413ac8f0281adb0771c5db7d789b2494f211 (resized).jpgQuoted from northerndude:see that these on the board look like MOSFET
They are not mosfets, just larger transistors. You ordered the correct part
Quoted from northerndude:For the testing, the diode at D5 and all other diodes on board are testing right on the money.
Replace it any way its .07 cents. Always replace a diode when a coil locks on.
Quoted from northerndude:*edit - found a bad diode at D12 also!
& D23
D-23 isn't bad, the coil from the AC relay made it test bad in circuit but it will test good out of circuit.
You're currently viewing posts by Pinsider GRUMPY.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/help-sys11-bally-game-show-sling-issue?tu=GRUMPY and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.