Moving forward on this game quite well. I had to completely disassemble the score reels as the grease that was used finally ceased up causing the drive motor to get quite toasty. I have been playing the game with a jumper across the bat relay in order for it to function.. more on that later. My kid seems to have taken to this machine and played a marathon session on it which came to an abrupt end when I noticed the start relay arcing. Things got pretty hot and melted the switch actuator shown in the picture. After searching on the internet for a replacement, I decided to blow off the dust of our 3d printer, model one up and printed it. Not bad for a first attempt, just needed a bit of filing and I was back in action. So today after the great success, I made a plate for the "bat" relay. Everything actually went very well, except after installing it... I have no bat control. I am not sure if someone altered the wiring or if I placed the contact in the wrong place. I made my assumption from the clean spot on the contact. If anyone has a Flash Baseball machine, please chime in as I have a couple other questions.
IMAG4737 (resized).jpgIMAG4740 (resized).jpgIMAG4744 (resized).jpgIMAG4750 (resized).jpgIMAG4754 (resized).jpg