Haunted House
Gottlieb, 1982You're currently viewing posts by Pinsider barakandl.
Click here to go back to viewing the entire thread.
Quoted from Smbel92:some of the pins on the connector do give out 5v but the 5v led isn’t coming on
Measure +5v using the ground wire in the PBDB connector. If you get no reading, but 5v is good if you use another ground, the ground wire is the likely problem then. Ground mods done? Without looking at the wiring diagram the PBDB ground return probably terminates on the ground block in the cabinet.
You're currently viewing posts by Pinsider barakandl.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/haunted-house-pop-bumper-problems-not-pop-bumper-board?tu=barakandl and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Centerport, NY