(Topic ID: 192828)

Haunted House need help please!

By Antennaejim

4 years ago



Topic Stats

  • 10 posts
  • 3 Pinsiders participating
  • Latest reply 4 years ago by Antennaejim
  • Topic is favorited by 1 Pinsider

You

Linked Games

You're currently viewing posts by Pinsider vdojaq.
Click here to go back to viewing the entire thread.

#4 4 years ago
Quoted from Antennaejim:

I have a switch or possibly a relay issue. I have gone through my switch test on my mpu as I have a pascal mpu. All switches test out fine. The issue is between the middle and lower playfield power. After the ball is shot up the vuk in the lower playfield to the middle playfield, the lights and flippers on the middle playfield are completely off until the ball drains then magically the middle playfield comes back to life sometimes it takes another ball drain. It's only the flippers and gi lights that don't activate. The solenoids and bumpers kick the ball around. I can't find any solutions to this particular issue in the forum and I have seen others post this same issue. Is this a common problem?

I believe there is a relay that controls the power for the main playfield and it sounds like it is not being tripped when the ball is shot up from the basement. The relay obviously is fine because when the ball drains on the main playfield it comes alive. I would tend to believe you have a switch that is not activating. Pinpoint your switch and I bet it needs adjustment, even if in the switch test it is fine.

#9 4 years ago

Check the diodes

You're currently viewing posts by Pinsider vdojaq.
Click here to go back to viewing the entire thread.

Hey there! Got a moment?

Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside