Hello,
I have a Haunted House I purchased a few weeks ago.
It has PI-80 main boards and Rottendog Pop Bumper boards.
Pretty much everything worked fine except there had been extensive repairs to it over the years.
Unfortunately, almost all of the repairs had been done with crimp connectors rather than soldering.
I've been removing the crimp connectors and soldering things properly and I have apparently screwed something up.
I plugged the Lower Playfield back in after doing a dozen or so fixes, Turned the Power ON, Pressed the Start Button...
As soon as the Ball kicks into the chute and it's time to play, I get the following:
- Coil 5 Error 2
- Coil 6 Error 2
From the schematic, it looks like:
- Coil 5 = Upstairs Playfield
- Coil 6 = Lower Playfield
- Error 2 = "No current is flooding thru the coil, although it is energized" (Got from another post...Not sure if this is correct...Can I look up error codes somewhere?)
The game does not go any further and does not allow me to play.
I hope someone can help me out.
Thanks,
Scott