Just got my very own HH. Worked perfectly when I got it from the seller. Disconnected it and got it home. Everything worked briefly. In the middle of my first game the ball got stuck in the middle VUK on the left and the score went blank. Numerous resets and I can’t get the scores to show at all. The game doesn’t even boot up. GI turns on but no scores show at all. Any ideas where to start looking?

Fuses are good specifically F3. DMM shows 60v at the A4-J1 connectors on all the displays. Backboard lights and flashers are running. GI is on but not the attract mode. It’s almost like the rom isn’t starting.

At the power block in the bottom of the cab I get 4v on the 8v terminal, 20v on the 25v. On the Gulf Power board I’m reading correct values on all the terminals. The interconnect cable reads continuity between the MPU and driver on all pins.

image (resized).jpg

image (resized).jpg

The spiderweb shield in the cellar. I’m sure it’s to prevent the ball from flying up and getting lost on the cabinet, but does anyone not use it? I feel it’s another layer of diffusion that doesn’t show the cellar well. Thoughts?

For those of you interested, I just found the perfect topper for HH. The Bradford Exchange sells a plastic haunted house with a ghost that lights up. The house is almost similar to the Backglass and it even has green lights! Go check it out! It’s as if this was made with the pin in mind!

6E11FD41-0368-4323-B033-E8F30819071D (resized).jpeg

8A337C64-AD73-4D5B-815D-1357E9014383 (resized).jpeg

What you can do is call them and just order the first item, the Haunted House, without the subscription. Unless you want the whole collection.

Hello group!

I’m having a strange pop bumper issue. The culprits are the pop in the attic and the lower left main PF pop. I start the first game after power on, and the bumpers fire for about two to three hits. Then they go dead. Fuse is working and they did work for a second. But after a few fires they just die. The other two pops work fine (Upper PF and Basement)
What should I be looking for. I will mention that this hasn’t had the pop bumper upgrade board yet. Thanks!

My Haunted House just died. First power on, the fourth score was brighter than the others and showed a fully lit score with the hashes in the middle. Reset the machine with a power cycle and it worked. Played two games. In the second game third ball, every switch just died including the flippers. Menu switch as well. Game is lit up and cycling through the lights as normal, but no switch works. Any clue where to start?

86 that. Simplest things sometimes. F4 solenoid fuse blew. Replaced it and back in business.

Just discovered a short causing my earlier issue with the f4 fuse. The bottom left main pop blew out f11. Replaced it and it blew immediately on startup. The pop bumper boards are new from Rottendog and haven’t had an issue for weeks. The coil feels warm. It was a slow fire as well, the bumper didn’t retract immediately. Diode issue or coil issue?

Marco sells it for 17.99