Quoted from HaggisPinball:Thanks to Cary for posting the review
I clarified a couple of points on the YouTube clip, so thought I would add them here as well:
Hi Cary - thanks for making the video - much appreciated
Just to clarify a couple of points:
1. Acrylic layer is 4.5mm (so a little under a 1/4 inch)
2. The plywood layer is 9mm, so I end up at a standard thickness playfield so standard mechs still fit
.....
Cheers,
Damian
So if the plywood is only 9mm thick will this give enough "meat" for the screws to dig into without easily stripping the wood? (also realize that there still has to be some room between the screw and the other side of the plywood...)