Any way to adjust the VUK? Was going to my left flipper now right down the middle. 
(Topic ID: 279715)
Linked Games
Guns N' Roses (CE)
Jersey Jack, 2020-
Guns N' Roses (LE)
Jersey Jack, 2020
-
Guns N' Roses (SE)
Jersey Jack, 2020
Topic Gallery
You're currently viewing posts by Pinsider skyemont.
Click here to go back to viewing the entire thread.
Quoted from ScreaminSauce:After a few hours of adjustments which 'sort of' worked, then went back to center, I ended up cutting a thin piece of a foam target to follow the right side of the scoop hood - works fantastic all the time now:[quoted image][quoted image]
Very nice.
I think I saw someone that switched springs on the outside plunger rod. Made it shorter. Did that help?
Quoted from Yelobird:The shorter plunger spring will give an additional 1/8” ish of throw. As others don’t have the same issue I would personally focus on centering and adjusting via the 3 screws on the back plate. Hard to believe one would be good and some not.
I fixed it a few days ago. It needed a .75 inch spring in lieu of 1 inch. The skull housing causes it to barely reach the pinball when plunging. Works great now.
1 week later
Quoted from Sammy31:I loaded 1.12 code and had no issues.
This time loading the new code the game has hung up...It's been in the "finishing update" page for a few hours now... what do I do? Just turn power off and try again?
No go back in and download again.
Promoted items from Pinside Marketplace and Pinside Shops!
Springfield, MO
You're currently viewing posts by Pinsider skyemont.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
