I velcro'd an amp on each of the ramps,and changed the normal lamp mounted on there to a LED's

DSCF0005.JPG

DSCF0006.JPG

poibug

I also added a shaker - it is actually provisioned in the software for the Japanese version of the G n R's (summat to do with it had tohave the same number of motors as Tommy IIRC).
So in solenoid test it says not used but it is as it tests and works in the game at various times - eg jackpot ramp shots and popper hits

Figured it out one day whilst going through the schematics IIRc.
Just used a standard shaker motor and resistor/fuse board from a Checkpoint a mate had parted.

did it years ago but will see if I can did out my schematic i made

poibug

Right,just found the notes i made

1.NEW CABLE IN BACKBOX from CPU CN12:9 to PPBJ8:11
2.RELOCATE KNOCKER DRIVE CABLE in backbox to PPB:J8:12(solenoid drive 16)and the cab end to shaker board J1 pins 6 and 7 on mine this was VIOL/GREY
3.The shaker board needs 9vac.I took this from the flipper board in the cabinet.
FLIPPER BOARD CN2:9 to shaker board J1:4 and 5
FLIPPER BOARD CN2:10 to shaker board J1 and 2
4.Obviously the shaker positive goes to shaker board J2:3 and 5 and negative to J2 and 2

As I said previously I used a checkpoint driver and shaker

poibug

Think MOP will go next to my Ramones pin

poi