Heres what i did and was pretty easy, simply place the figure on the lane plastics positioned one foot on each of the middle ones until its where it looks good to you.. What I did which worked pretty good was put masking tape around his feet to show where the feet would be after you remove the figure. Then take the plastic lane dividers off the machine and drill two small holes in them where the two holes on the slash figure's feet line up. Then use two screws and screw into the hole already in the figure's feet.

I didn't put the amp in myself as I didn't really like how it looked in there (to busy) but I've seen it mounted to the RH side near the pop bumpers usually. One thing to check before you put it in there the figure is only an 1/4 inch at most from hitting the glass when installed so make sure it fits before you commit to the spot. The farther back the better.

Those are awesome and agree they fit the theme much better. I'd be interested if you made more or even if you just had the file and we could make our own, that would work too.

You can also just print them out with a home printer and put Mylar over the decal. Might not look as good as some ways but not bad at all.

I'm not exactly local, but not too far away either if you wanted to use my game.