Hello all, I just got this GnR and everything in column 4(pop bumpers and slings) of the switch matrix is not working. When it goes into ball search everything fires off like it should. I checked voltages at the feed connecter on the CPU and the wire for that column is at 3.21 volts verses 4.42 volts at the other feed wires at that same connecter. I also got the same voltage readings at the pins with the connector off. All the diodes and wires on the string for that column look correct. Any help very much appreciated!

Thanks I will check that next.

I didn't see any shorts and the Q52 did test bad so that was the fix. Thank you very much for the guidance! So as a first time data east owner I'm a little frustrated with the menu. I would like to know how to open up the expanded adjustments. I have switched from no to yes but can never see where the expanded section is. Also I would like to know the best settings for tournament play.

So as a first time data east owner I'm a little frustrated with the menu. I would like to know how to open up the expanded adjustments. I have switched from no to yes but I haven't seen where the expanded section is. Are there adjustments for ball save and can the magnets be turned off or do you have to unplug them? Also I would like to know the best settings for tournament play. Thanks!

I love the magnets but tournament players will sit there and cradle balls and wait for them to time out.

I pressed it once to change from no to yes but it doesn't seem to accept the input like it does for other changes that I make in that same menu.

Also it is 3.0

After selecting yes and pressing the step button it just goes to the next adjustment. On the other adjustments it accepts the change I make after pressing the step button. In adjustments I have 1 thru 56 and then 99. Does anyone have more then that?

Thanks!