This may have already been covered here, but I had an issue with my Orb Drop Target not dropping. In coil test, I could see that the coil was in fact firing, but it seemed too weak to pull the bracket up and drop the target.
I tested the voltage of the coil, and it was fine.
My next assumption was that the bracket was getting jammed somehow. I found that when I placed the drop release bracket directly in the Center of the mech... it worked properly. So, I tried to get it to sit there using thin washers... but that didn’t work. In fact it made the issue worse.
My solution to the problem was VERY rudimentary, but it worked like a charm.
I simply torqued the entire mech slightly towards the lockdown bar. I surmised that this would leave the bracket with less distance to travel to grab the magnet, and drop the coil. It works perfectly now.
I applied gentle steady pressure to the entire mech, which bent the bracket ever so slightly and solved the issue. I hope this info is helpful.
AB818626-3628-4E53-B18D-B6DC0D1F2A4A (resized).jpeg