(Topic ID: 142878)

Gtb. Criss Cross coin door button not working

By Robo1

8 years ago



Topic Stats

You

Linked Games

You're currently viewing posts by Pinsider Robo1.
Click here to go back to viewing the entire thread.

#1 8 years ago

Hello everyone,
Cant seem to figure this one out. I am almost finished getting this game out of the dust. I can get it to start by manually triggering the restart coil on the relay bank, but I cant seem to find where the problem is with the coin door button. All the wires are intact, match unit wires are fine, i really believe the relay bank coil switches are fine......
any help would be great!
Thanks,
Rob

#3 8 years ago

Yes, The wires next to the coin door are aligned and screwed in tight, credits are on the game, zero position (on match unit?) i will check again but i just went over the switches on the unit. The game does start and play just perfect if i manually trigger the restart relay. There must be a gap somewhere in the power to that relay.
Is there a good way to jump the wires next to the coin door so I can confirm that the problem lays elsewhere?

#6 8 years ago

Dirt Flipper!
Thank you, I will check them all.......

#7 8 years ago

Right on! Thanks Dirtflipper, the switch in the start relay was not making clean contact.

Promoted items from Pinside Marketplace and Pinside Shops!
1,750 (OBO)
Machine - For Sale
Alameda, CA
900 (OBO)
Machine - For Sale
Murrells Inlet, SC

You're currently viewing posts by Pinsider Robo1.
Click here to go back to viewing the entire thread.

Reply

Wanna join the discussion? Please sign in to reply to this topic.

Hey there! Welcome to Pinside!

Donate to Pinside

Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!


This page was printed from https://pinside.com/pinball/forum/topic/gtb-criss-cross-coin-door-button-not-working?tu=Robo1 and we tried optimising it for printing. Some page elements may have been deliberately hidden.

Scan the QR code on the left to jump to the URL this document was printed from.