Hey Guys, I've been working on a Shaq Attaq which has been giving me so much trouble! Finally got the game working. Went to add some LEDs, everything was going great. Added a few more LEDs here and there, then when I booted it one time, it looked like the lamp patterns (attract mode playfield sweeps) were stuttering, and then suddenly just lost all lamps. Also lost all switches too (diagnostics shows "ALL SWITCHES OPEN"). The test button is the only thing that works, but I don't have flipper or start button switches so I can't use the diagnostics. I checked all fuses and they're all good. I get normal boot and all boards appear to be working. In the manual it says that this could be a symptom of a bad driver board, so I tried switching out the driver board with a new rottendog board and still the same issue. I read on Pinwiki that it could be a bad ribbon cable so I have replaced all of the ribbon cables as well- no difference. Can anyone point me in the right direction?