Warren, PA
All of the optical sensors on my Stargate stopped working after I installed a new coil for the left VUK. I replaced the board, and still nothing. Any help would be appreciated.
(Topic ID: 231553)
You're currently viewing posts by Pinsider mrossman5.
Click here to go back to viewing the entire thread.
1 month later
Quoted from Benhurr:You might shunt all ground wires as it preconised on pinrepair.com before test any electrical component.
Also unplugged and clean any connector by scratching pin and use electrical spray cleaner...wait for an hour before power on.
Search for the optical quad interface sensor board who is located under playfield at the bottom right. Red diode must shine on it if sensor not work...if not that came from the connector or not powered on..
One time two of four diode don't work on mine...just unplugged it clean connector and also resold any sensor wires and works fine now...the most important on any Gottlieb System is to shunt any ground wires 1st.
Good luck
[quoted image]
Thank you!
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider mrossman5.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
